AERMEC VMF-E5 - Set Heating Temperature for Chiller; Set Cooling Temperature for Chiller

40
GB
6795773_01
In winter, the user will set the desired room air temperature by
means of the thermostat on the master fan coils. To reach this
temperature, the unit will produce hot water at the temperature
set by the installer indicated in this parameter (between 30.0 and
70.0°C);
to set this value it is necessary to:
(1) Enter modifi cation mode by pressing the
C
key; after
this key has been pressed, the current band value will be
highlighted.
(2) Press the
A
or
B
key to modify the heating work setting
of the chiller.
(3) Press the
C
key to confi rm the value entered; once this
key has been pressed, the current setting will be highlighted
normally, thus indicating that the modifi cation procedure has
concluded.
After the data has been entered, it will be possible to:
- Pass on to the following window by pressing the
B
key.
- Go back to the previous window by pressing the
A
key.
- Press the
D
key to return to the selection of the menus.
• Set heating temperature for chiller
In the proposed example, the temperature
of the hot water produced by the chiller
for the system demand is 45°C, as this
value is appropriate for the type of utility
(fan coil) used in the system.
In summer, the user will set the desired room air temperature by
means of the thermostat on the master fan coils. To reach this
temperature, the unit will produce cold water at the temperature
set by the installer indicated in this parameter (between 00.0 and
20.0°C);
to set this value it is necessary to:
(1) Enter modifi cation mode by pressing the
C
key; after
this key has been pressed, the current band value will be
highlighted.
(2) Press the
A
or
B
key to modify the cooling work setting
of the chiller.
(3) Press the
C
key to confi rm the value entered; once this
key has been pressed, the current setting will be highlighted
normally, thus indicating that the modifi cation procedure has
concluded.
After the data has been entered, it will be possible to:
- Pass on to the following window by pressing the
B
key.
- Go back to the previous window by pressing the
A
key.
- Press the
D
key to return to the selection of the menus.
• Set cooling temperature for chiller
In the proposed example, the temperature
of the hot water produced by the chiller
for the system demand is 45°C, as this
value is appropriate for the type of utility
(fan coil) used in the system.
A
B
C
D
Hot setting chiller
ESC
45.0 C
A
B
C
D
Could setting chiller
ESC
45.0 C