AERMEC WRC40 - Page 15

15
The HEALTH function enable or disable the air
purifier Cold Plasma function capable of reducing
pollutants breaking down their molecules using
electric discharges, causing the splitting of the
water molecules in the air into positive and negative
ions. These ions neutralise the molecules of the
gaseous pollutants obtaining products that are
normally present in clean air. The device is able to
eliminate 90% of the bacteria. The result is clean,
ionised air that has no bad odours.
FUNCTION NOT AVAILABLE.
HEALTH  AIR PURIFIER COLD PLASMA
AUXILIARY HEATING
When this function (only available in cooling mode)
is activated, the unit works in energy saving mode.
When the I-DEMAND function is active, the unit fan
speed is determined automatically. This function
cannot be activated at the same time as the SLEEP
function.
IDEMAND FUNCTION
The HOLIDAY function enable or disable antifreeze
function, only available in heating mode, makes it
possible to keep an operation setpoint in heating
mode equivalent to 8 °C, ensuring thus that
the room temperature does not go below this
threshold.
This function is automatically disabled if any other
mode than heating is set. This function cannot be
activated at the same time as the SLEEP function.
MEMORY is a function that allows the automatic
saving of the working set-point used. Following
an accidental interruption of the power supply for
example, the unit will automatically adopt the last
working set-point imposed.
The SAVE function is used to set a minimum
temperature limit for cooling and dehumidifica-
tion modes, and a maximum temperature limit for
heating mode. This allows the unit to work within a
temperature range that guarantees energy savings.
After selecting the SAVE function, use the
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
button to choose whether to set the cooling or
heating limit. To set the required value, use the
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
button.
HOLIDAY  ANTIFREEZE FUNCTION
MEMORY FUNCTION
SAVE
The DRY function enable the X-FAN function. Dur-
ing the operation in cooling or dehumidification
mode the condensate caused by the humidity in the
air is formed on the heat exchanger within the unit.
The X-FAN function allows, when the air conditioner
is off, to perfectly dry the coil and avoid the forma-
tion and proliferation of pathogens.
The FILTER CLEAN function is used to define
the time that must elapse before a filter cleaning
reminder is given.
After selecting the function and entering the
relative sub-menu, use the
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
button to
select one of the three filter duration levels:
Level 1 = lifespan 5500~10000 hours
Level 2 = lifespan 1400~5000 hours
Level 3 = lifespan 100~1000 hours
After selecting the required level, the
MENU/OK
FAN
ON/OFF
MODE
SWING
or
MENU/OK
FAN
ON/OFF
MODE
SWING
button
can be used to set the number of hours that must
elapse before the filter cleaning reminder is given.
Each level has hour steps:
Level 1 = 500-hour steps
Level 2 = 400-hour steps
Level 3 = 100-hour steps
Press
MENU/OK
FAN
ON/OFF
MODE
SWING
to save the settings.
Every time this function is deactivated, the unit
operating time will be reset.
DRY  XFAN FUNCTION
FILTER CLEAN  FILTER CLEANING REMINDER