Fig. 21
(1) Hydraulic pressure
(2) PTO speed
7. Make sure that the PTO speed and the hydraulic
pressure show on the home page of the display.
8. Lower the baler pick-up and drive into a windrow to make a bale.
9. Do a check of the bale flake chart when you make a bale.
10. Adjust the ground speed of the machine if the bale flake dimension is not correct.
Result
The correct bale flake dimension is when the bars are near to the center of the chart range.
11. Continue to examine the bale parameters as you make the bales. Adjust the machine if it is necessary.
3 Operation
48
SimplEbale
To Next Page
Loading...
