AGFA DR 100e - Starting the NX Workstation and the DR Detector

Starting the NX workstation and the DR Detector
The all-in-one PC and the DR Detector are battery powered. They can be
started while the X-ray device is switched off.
1. Switch on the all-in-one PC by pressing and holding the power button for 2
seconds.
For detailed information about starting up NX, refer to the NX User
Manual, document 4420.
2. Power on the DR Detector.
a) Attach a fully charged battery pack to the DR Detector.
b) Turn on the DR Detector.
c) If needed, register the DR Detector to the DR 100e system.
For detailed information about powering on the DR Detector, refer to the
DR Detector user manual.
Related Links
Connectors for the hospital network and for registering a DR Detector on page 29
NX Workstation (all-in-one PC) on page 20
DR 100e (Digital Radiography) | Basic Workflow | 63
0365B EN 20181015 0853