AGFA DR 100e - Using the NX Workstation with the X-Ray System Switched off

Using the NX workstation with the X-ray system
switched off
The NX workstation can be left on while the X-ray device is switched off, for a
limited period of time, less than ten minutes, e.g. for moving the device to the
next patient.
When the NX workstation must be operated while the X-ray device is switched
off for a longer period of time, e.g. for processing the images, the mains cable
must be plugged in to a mains socket while operating the NX workstation.
When stopping the NX workstation, also disconnect the mains cable from the
mains socket.
Related Links
Connecting DR 100e to a wired network on page 97
DR 100e (Digital Radiography) | Basic Workflow | 81
0365B EN 20181015 0853