Agilent Technologies 1200 series - Page 157

Agilent 1200 Preparative Pump User Manual 157
Configuring the Preparative Pump
9
Optional Interface Boards
LAN Communication Interface Board
The Agilent 1100/1200 Series modules have one optional board slot that
allows to add an interface board to the modules. Some modules do not have
this interface slot. Refer to “Agilent 1100/1200 Series Interfaces” on page 16
for details.
The following cards can be used with the Agilent 1200 Series modules.
Description Part Number
LAN Communication Interface Board G1369A
G1369-60001
NOTE
One board is required per Agilent 1200 stack. It is recommended to add the LAN board to
the detector with highest data rate.
NOTE
For the configuration of the G1369A Lan Communication Interface card refer to its
documenation.
Tabl e 23 LAN Boards
Type Vendor Supported networks
G1369A
G1369-60001
Agilent Technologies Fast Ethernet, Ethernet/802.3, RJ-45
(10/100Base-TX) recommended for re-ordering
J4106A (*) Hewlett Packard Ethernet/802.3, RJ-45 (10Base-T(
J4105A (*) Hewlett Packard Token Ring/802.5, DB9, RJ-45 (10Base-T)
J4100A (*) Hewlett Packard Fast Ethernet, Ethernet/802.3, RJ-45
(10/100Base-TX) + BNC (10Base2)
NOTE
These cards (*) may be no longer orderable. Minimum firmware of these Hewlett Packard
JetDirect cards is A.05.05.