Agilent Technologies 1200 series - Agilent 1200 Series Interfaces

Agilent 1200 Preparative Pump User Manual 159
Configuring the Preparative Pump
9
Agilent 1200 Series Interfaces
Agilent 1200 Series Interfaces
Analog Signal Output
The analog output connector(s) provide an analog signal output (pressure
signal). The analogue data are digitalized by an A/D-converter and can then be
distributed to a PC, which is running with a non-Agilent operating system that
does not communicate via GPIB.
For details refer to the description of the main board of the module.
GPIB Interface
The GPIB connector serves as the default interface between an Agilent 1200
Series module and the Agilent Control Software.
The GPIB connector is used to connect the module with a computer. The
address and control switches next to the GPIB connector determine the GPIB
address of your module. The switches are preset to a default address and
recognized by the operating software from Agilent Technologies.
CAN Interface
The CAN connectors serve as the interface between the Agilent 1200 Series
modules themselves. All modules in the Stack must be interconnected. It is a 2
wire serial bus system supporting high speed data communication and
real-time requirements.