Agilent Technologies 1200 series - Page 35

Agilent 1200 Preparative Pump User Manual 35
Installing the Pump
3
Optimizing the Stack Configuration
Figure 6 Recommended Stack Configuration - Preparative System (Rear View)
NOTE
For information about connecting an LC-MSD or a None-1200 Series detector to the
system, please refer to the “User’s Guide for Purification / High Throughput System”, PN
G2262-90010 or to the “Installation Note for the Mass Based Fraction Collection Kit”.
JK"K^h
;gVXi^dc
8daaZXidg
9ZiZXidg
EgZeVgVi^kZ
Ejbe6
EgZeVgVi^kZ
Ejbe7
HdakZci
8dbeVgibZci
6jidhVbeaZg
8dajbcDg\Vc^oZg
<E>7dgA6C
id8]ZbHiVi^dc
86C7jh
8VWaZ
NOTE
If a G1330B ALS thermostat is part of the system it must always be installed underneath
the Autosampler.