8 Agilent 2200 TapeStation System - User Manual
1 Introduction to the 2200 TapeStation System
Overview of the System
Agilent 2200 TapeStation Instrument Components
Lid: The 2200 TapeStation instrument lid must be closed each time the 2200
TapeStation Controller Software is initialized, and whilst the instrument is
in operation.
LED: The LED will illuminate once the instrument is on. When the LED is
flashing slowly, the instrument is in use and the lid should not be opened,
rapid flashing indicates that the 2200 TapeStation instrument requires
attention.
Sample Block: There are 2 sample blocks provided that can either hold 0.2 mL sample
tube strips or a 96-well plate.
Tip Holder: The tip holder can accommodate up to 16 loading tips at any one time.
ScreenTape device: The ScreenTape device must be placed into the holder with the barcode
towards the front of the instrument, facing towards the right.
USB Socket: The USB connector is inserted into the USB socket to link the laptop to the
2200 TapeStation instrument.
Power-cable socket: The power cable must be connected to the 2200 TapeStation instrument
and the relevant mains electricity outlet.
To Next Page
Loading...
