Agilent 2200 TapeStation System - User Manual 31
Installing the System
3
Installing the System
Agilent 2200 TapeStation System Set Up
1 Connect the supplied USB cable between the port on the back of the
2200 TapeStation instrument and your laptop.
2 Power the instrument with the supplied power lead and adaptor.
3 Turn the instrument on using the power switch located at the back of
the 2200 TapeStation instrument.
When powered and idle, the instrument will have a blue LED visible on
the front of the case.
Hardware required Laptop
Software required Agilent Software packages (2200 TapeStation Controller Software, and TapeStation Analysis
Software) (already installed)
Personal injury, explosion or fire
➔ Do not operate the instrument in an atmosphere containing explosive gases or near
flammable volatile liquids.
➔ Only approved mains cord set supplied with the instrument must be used with this
instrument and if an extension lead is required, the lead must be earthed.
➔ If the equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
For general safety information, please refer to the 2200 TapeStation System - Site and
Safety Manual.
Use of unsupplied cables or power adaptors
Using cables or power adaptors not supplied by Agilent Technologies can lead to
damage of the electronic components or personal injury.
➔ Never use cables or power adaptors other than the ones supplied by Agilent
Technologies to ensure proper functionality and compliance with safety or EMC
regulations.
To Next Page
Loading...
Need help?
General
