120 Troubleshooting and Maintenance Manual
4 General Maintenance
ground. If that is not possible, it should be connected to a conductive (metal)
part of the assembly being worked on, but
not to electronic components,
exposed wires or traces, or pins on connectors.
Take extra precautions, such as a grounded antistatic mat, if you must work
on components or assemblies that have been removed from the MS. This
includes the analyzer.
More information is available
If you need more information about the functions of electronic components,
refer to Chapter 8, “Electronics” on page 165.
In order to be effective, an antistatic wrist strap must fit snugly (not tight). A loose
strap provides little or no protection.
Antistatic precautions are not 100% effective. Handle electronic circuit boards as little
as possible and then only by the edges. Never touch the components, exposed traces,
or pins on connectors and cables.
To Next Page
Loading...
Need help?
General
