Agilent Technologies 81104A - Perform Operation “Calibrate”; Parameter Grouping (Group Params by)

104
Using the 81110A/81104A
T
TT
The
he he
he C
CC
Co
oo
on
nn
nf
ff
fi
ii
igu
gugu
gur
rr
ra
aa
at
tt
ti
ii
io
oo
on
n n
n S
SS
Sc
cc
cr
rr
ree
eeee
een
nn
n
Perform Operation Calibrate
Select C
ALIBRATE
in the MODIFY area.
Start the timing calibration for the VFO-period, delay and width
circuitries by pressing ENTER.
If the calibration fails, a flashing E is displayed. Press H
ELP
to see the list
of error messages.
N
NN
NO
OO
OTE
TETE
TE Timing Calibration is available for Agilent 81110A only.
Parameter Grouping (Group Params by)
N
NN
NO
OO
OTE
TETE
TE This option is only available if your Agilent 81110A or Agilent 81104A
mainframe is equipped with two output modules.
Configure the grouping of the pulse-parameters on the user interface:

TIMING/LEVELS
The pulse timing parameters for outputs 1 and 2 are grouped together
on the Timing screen.
The pulse-level parameters for outputs 1 and 2 are grouped together
on the Levels screen.

OUTPUT 1/2
All timing and level parameters for output 1 are grouped together on
the Output 1 screen.
All timing and level parameters for output 2 are grouped together on
the Output 2 parameter screen.