EasyManuals Logo

Agilent Technologies 8720ES Service Guide

Agilent Technologies 8720ES
617 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
Chapter 2 2-75
System Verification and Performance Tests
Agilent 8753ES System Verification and Performance Tests
13. Test Port Receiver Phase Compression
Perform this test to verify the phase compression/expansion of the analyzer’s test port
receivers. Power sweeps from low to high power are made at designated CW frequencies. A
reference measurement is made while the signal to the receiver is attenuated to avoid
compression. The attenuation is removed and compression is observed and measured.
Analyzer warm-up time: 30 minutes
Specifications
Required Equipment for 50Ω Analyzers
Procedure
1. Connect the equipment as shown in Figure 2-42 (Figure 2-43 for 75Ω analyzers).
CW Frequency Test Port
Phase
a
a. With 10 Hz IF bandwidth.
300 kHz to 3 GHz Test Port 1 ≤ 6°
3 GHz to 6 GHz
b
b. Only for analyzers with Option 006.
Test Port 1 ≤ 7.2°
Description HP/Agilent Part or Model Number
Cables (2): 50Ω, APC-7 8120-4779
Step Attenuator 8496A Option 003, H18
Additional Equipment for 75Ω Analyzers
Minimum Loss Pad (2) 11852B
Adapters (2): APC-7 to Type-N (f) 11524A
Cables (2): 50Ω, Type-N, 24-inch 8120-4781

Table of Contents

Other manuals for Agilent Technologies 8720ES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Agilent Technologies 8720ES and is the answer not in the manual?

Agilent Technologies 8720ES Specifications

General IconGeneral
BrandAgilent Technologies
Model8720ES
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals