Quick Start
If the power-on self test fails, the display shows ERR in the upper right corner. It also prominently displays "Check for
error messages in the error queue."
See SCPI Error Messages for information on error codes. See Service and Repair - Introduction for instructions on
returning the instrument for service.
To turn off the instrument, hold the power switch down for about 500 ms. This prevents you from accidentally turning
the instrument off by brushing against the power switch.
Adjust the Carrying Handle
Grasp the sides of the handle, pull outward, and rotate the handle.
Set Output Frequency
The default frequency is 1 kHz. You can change the frequency, and you can specify frequency in units of period instead
of Hz.
18 Agilent 33500 Series Operating and Service Guide
To Next Page
Loading...
