SCPI Error Messages
ramp Symmetry
Sample rate
sample rate clipped to lower limit
sample rate clipped to upper limit
quare edge time
square edge time limited by duty cycle
square edge time limited by period
square edge time limited by width
square period
square width
sum amplitude limited by channel or combine amplitudes
sum amplitude value clipped to lower limit
sweep time
Track exceeds limits on channel 1. Tracking disabled
Track exceeds limits on channel 2. Tracking disabled
trigger count clipped to lower limit
trigger count clipped to upper limit
trigger delay
trigger delay clipped to lower limit
trigger delay clipped to upper limit
trigger delay limited by length of burst
trigger timer clipped to lower limit
trigger timer clipped to upper limit
trigger timer limited by length of burst
user frequency
USER setting only valid for channel 1
value clipped to dwell time's lower limit
value clipped to dwell time's upper limit
value clipped to lower limit
value clipped to sweep time's lower limit
value clipped to upper limit
value limited due to coupling
-222 List Data out of range; pulse frequency : Mode is changed to continuous wave
-222 List Data out of range; ramp frequency : Mode is changed to continuous wave
358 Agilent 33500 Series Operating and Service Guide
To Next Page
Loading...
