Power Meter Operation 2
E4418B Power Meter User’s Guide 77
To select the format of the display in the currently selected window:
1 Press , .
2 Press to highlight the type of format you require.
Pressing this key toggles between a digital and analog display.
To select the range of the analog display in the currently selected window:
1 Press , , .
2 The current setting of the maximum and minimum values displayed on
the analog meter are displayed under the
and softkeys
respectively.
3 To change either of these settings, press the appropriate softkey. The
power meter displays the current value in a pop- up window. Modify
this value (see below) until the desired value is displayed.
• Use or to modify the digit on which the cursor is
currently positioned.
• Use or to move to other digits.
4 The choices available depend on the unit of measurement selected and
the current measurement mode. If the measurement unit selected is
logarithmic, then the choice will be
or . If the measurement
unit selected is linear, then choose the appropriate softkeys from the
following menus:
Increment
Decrement
Multiplier
Multiplier
Cancel
%
Cancel
Increment
Decrement
Multiplier
Multiplier
Cancel
mW
nW
μW
Cancel
W
%
To Next Page
Loading...
