Agilent Technologies G1314B VWD Reference Manual

Agilent 1200 Series Autosampler Reference Manual 159
Repairing the Autosampler 4
4 Install the transport assembly (page 139).
5 Install the top cover and foam (page 134).
6 Turn ON the autosampler.
7 Enter the 10-character autosampler serial number. The serial number can
be entered using either the control module or the ChemStation, see
“Entering the Serial Number using the Control Module” on page 163 or
see“Entering the Serial Number using the ChemStation” on page 165.
8 Check the firmware revision of the autosampler. If the firmware revision is
older than the current firmware revision of the autosampler, update the
firmware, see “Replacing the Autosampler Firmware” on page 166

Agilent Technologies G1314B VWD Specifications

General

Brand	Agilent Technologies
Model	G1314B VWD
Category	Laboratory Equipment
Language	English