Agilent Technologies G7104C User Manual

1260 Infinity II Flexible Pump User Manual 285
12 LAN Configuration
Initialization Mode Selection
Initialization Mode Selection
The following initialization (init) modes are selectable:
Using Stored
When initialization mode Using Stored is selected, the parameters are taken from
the non-volatile memory of the module. The TCP/IP connection will be
established using these parameters. The parameters were configured previously
by one of the described methods.
Figure 31 Using Stored (Principle)
Table 24 Initialization Mode Switches
SW 6 SW 7 SW 8 Init Mode
OFF ON OFF Using Stored
OFFONONUsing Default
ON OFF OFF
DHCP
1
1
Requires firmware B.06.40 or above. Modules without LAN on board, see G1369C LAN Interface Card
Non-Volatile
RAM
Stored
Parameter
Active
Parameter

Agilent Technologies G7104C Specifications

General

Brand	Agilent Technologies
Model	G7104C
Category	Laboratory Equipment
Language	English