1260 Infinity II Flexible Pump User Manual 77
3Using the Module
Setting up the Pump with the Instrument Control Interface
Control Settings
The pump control parameters are in two sections:
•Pump
•Automatic Turn On
Method Parameter Settings
The pump method setup parameters are in nine sections:
•Flow
•Solvents A to D
•Stoptime
•Posttime
• Pressure Limits
•Timetable
•Advanced
• Blend Assist
•ISET
Table 8 Pump control parameters
Parameter Description
Pump Enables you to switch the pump On, Off or to a Standby condition.
In the Standby condition, the pump motor is still active, and when the pump is switched on again, it
does not need to be re-initialized.
Automatic Turn On Module can be turned on at a specified date/time. This feature can only be used if the module power
switch is turned on.
To Next Page
Loading...
Need help?
General
