4 Agilent Intuvo 9000 GC Installation
Install filters and traps, then purge. 46
Install traps 46
Connect gases to the GC. 47
Plumb to EPC flow modules 47
Leak test all connections and set source pressures. 49
Vent hazardous gases to a fume hood. 51
Install FID vent chimney 51
Connect cryogenic cooling (if present). 53
Connecting liquid carbon dioxide 53
Connecting liquid nitrogen 54
Connecting air to the multimode inlet 56
Connect valve actuator air (if present). 58
Connect the external cables. 59
Back panel connectors 59
Connecting cables 61
Labeling BCD and EVENT cables 61
GC / MS / Agilent data system / ALS 62
Additional cabling configurations 62
Install ALS, if available. 63
Install tray bracket onto the tray (7693A only) 63
Install the tray on the GC (7693A only) 65
Install the injector 66
Configure the ALS 67
Calibrate the tray, if installed 68
Prepare the ALS for checkout 69
Install the Intuvo chips and column. 70
Remove the packing materials 71
Install the Intuvo inlet chip and Guard chip 73
Install a new column gasket 78
Install the checkout column 80
Condition the column and bake out the detector. 85
Transfer the checkout sample to a screw-top sample vial. 86
Enter the checkout method. 87
Run one injection. 88
Evaluate Results. 89
Prepare for the next analysis. 90
If appropriate, update firmware. 91
GC firmware 91
To Next Page
Loading...
Need help?
General
