Agilent Technologies Intuvo 9000 - Prepare the als for Checkout

Installing the GC 1
Agilent Intuvo 9000 GC Installation 69
When calibration succeeds, the tray is ready for use.
Prepare the ALS for checkout
1 Prepare a 2-mL screw-top sample vial.
2 Prepare 4-mL waste vials and place them into the turret.
3 Prepare fresh solvent solutions as needed for the checkout
sample for your detector type. Place the solvent vials into the
injector turret. For details on the solvent needed, see the
Agilent Intuvo 9000 GC Operation Manual.