Airo X RT Series - Stopping the 380 V Three-Phase or 230 V Single-Phase Electrical Pump (Optional); Manual Emergency Lowering; Manual Emergency Lowering: Standard Control

Use and Maintenance Manual - X_RT Series Page 45
5.5.4 Stopping the 380V three-phase or 230V single-phase electrical pump (optional)
To stop the electrical pump (optional):
On the platform control panel:
 Press the stop button.
 Otherwise, press the emergency stop button.
On the ground control panel:
 Press the emergency stop button.
5.6 Manual emergency lowering
This function is to be used only in emergency situations, when no motive power is available.
IT IS FORBIDDEN to use the manual emergency lowering control to lower the platform with overloads.
5.6.1 Manual emergency lowering: Standard control
Fig. 12
In case of fault in the electric or hydraulic system, to carry out the emergency manual lowering pull the knobs indicated in (Figure )
to the outside.
To operate the manual lowering it is necessary to pull both handles with the sequence indicated on the instruction plate on the
machine.
Caution, the emergency control can be stopped at any time by releasing the knobs.