Airo X RT Series - Overload Controller By-Pass - ONLY for EMERGENCY OPERATIONS

To Next Page

To Previous Page

Use and Maintenance Manual - X_RT Series Page 72

7.3.13 Overload controller by-pass – ONLY FOR EMERGENCY OPERATIONS

In case of fault and impossibility to calibrate the device, a by

pass of

the system is possible by means of locking key switch (A) under the

control panel. Keep the locking key switch active for 5 seconds and

release to get the BY-PASS condition.

WARNING!! IN THIS CONDITION THE MACHINE CAN CARRY OUT

ANY OPERATION, THOUGH THE RED FLASHING LED AND THE

AUDIBLE ALARM SIGNAL THE DANGER CONDITION. TURNING

OFF THE MACHINE WILL RESET THE SYSTEM, AND UPON

STARTING, THE OVERLOAD CONTROLLER OPERATES AGAIN

SIGNALLING THE PREVIOUS OVERLOAD CONDITION.

THIS OPERATION IS ALLOWED ONLY FOR EMERGENCY

HANDLING OF THE MACHINE. DO NOT USE THE MACHINE IF

THE OVERLOAD CONTROLLER IS NOT EFFICIENT.

Fig. 32

WARNING!

THIS OPERATION IS ALLOWED ONLY FOR EMERGENCY HANDLING OF THE MACHINE OR IN THE EVENT

OF A FAULT OR IMPOSSIBILITY TO CALIBRATE THE SYSTEM.

DO NOT USE THE MACHINE IF THE OVERLOAD CONTROLLER IS NOT EFFICIENT.