Airo X RT Series - Dead-Man Button Efficiency Check

Use and Maintenance Manual - X_RT Series Page 75
7.3.15 Dead-man button efficiency check
The platform dead-man button is for enabling the operation controls of the machine from the platform control station.
Check operation at least once a year.
WARNING!
IN CASE OF NO OPERATION, CONTACT THE AFTER-SALES SERVICE
To check the dead-man BUTTON:
 Move the drive joystick forward and backward in sequence, WITHOUT PRESSING THE DEAD-MAN BUTTON
 Check that the machine does not perform any movement
 Press dead-man button, release it and wait more than 5 seconds
 move the joystick forward and backward in sequence
 Check that the machine does not perform any movement
If the device works properly, no machine manoeuvre is possible from the platform control panel unless you press the dead-man
button beforehand. If this is pressed for more than 5 seconds and no operation is performed, all movements are disabled; to
operate the machine again, release the dead-man button and press it again.
The condition of the switch is indicated by the green led in the platform:
 green led lit up steady control panel enabled
 green led lit up flashing control panel disabled