Airspan ProST - User Manual

71 pages

Save Page as PDF

To Next Page

UGD-D00111 Rev L

ProST

Hardware Installation

User Guide

Software Release 7.7

Main Page

Other manuals for Airspan ProST

Hardware Installation Guide78 pages

Questions and Answers

C
Christopher MitchellAug 1, 2025
What to do if Airspan ProST SDA-1 is not receiving power?
- A
  Andrea MasseyAug 2, 2025
  If the Airspan Antenna SDA-1 is not receiving power, check the following: * Ensure the wall outlet provides electricity (professional electrician required). * Make sure the SDA-1 plug prongs are completely inserted into the wall outlet socket. * Verify the SDA-1 plug prongs are correctly attached to the SDA-1: prongs inserted into the prong grooves, slid to the end, and the switch is in the LOCK position. * Confirm that the network cables are plugged into the correct SDA-1 ports: RADIO port for ProST-to-SDA-1 connectivity and LAN/PC port for computer-to-SDA-1 connectivity.
D
David FoxAug 16, 2025
What to do if Airspan Wireless Access Point SDA-1 is not receiving power?
- B
  Bill SmithAug 16, 2025
  If your Airspan Wireless Access Point SDA-1 and ProST are not receiving power and the power LED is off, here's what you can check: 1. **Wall Outlet:** Ensure the wall outlet is providing electricity. It might be necessary to consult a professional electrician. 2. **Plug Insertion:** Make sure the SDA-1 plug prongs are fully inserted into the wall outlet socket. 3. **Prong Attachment:** Verify the SDA-1 plug prongs are correctly attached to the SDA-1. Remove and reinsert them, ensuring they are in the prong grooves, slid to the end, and the switch is in the LOCK position. 4. **Cable Placement:** Confirm that the network cables are in the correct SDA-1 ports. The port labeled 'RADIO' is for ProST-to-SDA-1 connectivity, and the port labeled 'LAN/PC' is for computer-to-SDA-1 connectivity.