EDITING - 14
Version 2.00 - March, 1996 Page 101
ERASE TO CLIPBOARD
ERASE is similar to CUT except that it will remove the currently selected edit region/cue(s)
but will keep the gap thus created.
IN OUT
IN OUT
BEFORE ERASE
AFTER ERASE
Pressing ERASE will give you this screen:
As with the other screens we have seen so far, the length you are about to erase is
shown. When you press EXECUTE now, the selected edit region/cue(s) will be erased and
placed in default clipboard 0 and given the default name Clip 0. If you wish, you may
erase the edit region/cue(s) and place it in one of the clipboards 1-9. You may also name
it prior to erasing it by pressing NAME and entering a ten character name.
You may also select the type of edit you wish to erase using F1 - TYPE?. There are two
choices you can make. WHOLE REGION selects that everything within the IN/OUT region
will be erased:
PLAY
PLAY
EDIT
PLAY
PLAY
BLUE (PLAY) GREEN (SELECTED)
IN OUT
EDIT
EDIT
EDIT
Selecting ONLY WHOLE CUES will copy only the whole cues whose’ start and end fall
within the edit region:
PLAY
PLAY
EDIT
PLAY
PLAY
BLUE (PLAY) OCHRE (SELECTED)
IN OUT
EDIT
EDIT
EDIT
Cues whose start and end fall outside the edit region will not be erased. When ONLY
WHOLE CUES is selected, the selected cues will be highlighted ochre on the external
monitor.
NOTE: The selection made here is retained when you leave the page. When you
subsequently re-enter the ERASE page, the same selection as you made previously will
be shown.
To Next Page
Loading...
Need help?
General
