EDITING - 14
Version 2.00 - March, 1996 Page 127
SLIPPING WHOLE TRACK USING SLIP PRE
In the TRIM SET page (SHIFT+TRIM), you may also set whether slipping a cue in TRIM
will cause only the cue you are trimming to slip or the all audio before it. When SLIP
WHOLE TRACK is selected, the LCD will display this screen:
This indicates that all cues before the cue being slipped are also ‘active’ and will slip in
time. The effect on the audio would be:
NOTE: In SLIPPING PRE, when the start of the very first cue in the project reaches zero
(00:00:00:00.0), you will receive the TRIM REGION LIMIT prompt as you will have run out
of room to slip cues any further.
To Next Page
Loading...
