SYSTEM SETUP - 10
Version 2.00 - March, 1996 Page 57
SHOW (SHIFT+SYSTEM)
The SYSTEM key’s SHIFT function is SHOW. When you press SHIFT+SYSTEM, the key’s
LED will flash and you will receive the following screen display:
The options are split across two pages. The first page shown above offers the following:
CUE INFORMATION Allows you to select:
CUE NAMES This will show the names of the current
and, depending on the direction of
playback/jogging/etc., the next or
previous cues will be listed for each
track down the right of the GRID.
DISK IDS This will show the SCSI ID numbers of
the disk drives the cues are playing
from will be shown down the right of the
GRID
DISK LABELS This will show the disk label given in the
FORMAT page down the right of the
GRID.
DISK NAMES This will show the name given to the
disk in the FORMAT page down the
right of the GRID.
CUE FADES These can be switched ON or OFF. Scrolling is slightly
smoother with the fades switched off.
CUE LEVEL It is possible to show the cue’s level with this option. The
height of the blue box surrounding the waveform will vary
according to its level (although this does have the effect of
making the waveform display look off centre). CUE LEVEL
may be switched ON or OFF.
WAVEFORMS You may select whether the cues’ envelopes are shown on
the GRID and the options are ON or OFF. You will note
that scrolling is slightly smoother with the waveforms
switched OFF.
MAG You may set the vertical magnification of the waveform
envelopes. You may also do the same thing at any time
more conveniently using SHIFT+DATA ENTRY +/-.
EDIT AUTO ZOOM This function has three settings: OFF/MANUAL/AUTO.
With the parameter switched OFF, the vertical zoom in/out
will zoom in from 16 tracks through 12, 8, 4, 2 and finally 1
track shown on the VGA monitor.
To Next Page
Loading...
