16 - UTILITIES - LOADING PROJECTS
Page 152 Version 2.00 - March, 1996
EXT M/C SYSTEM
USER KEYS MACRO
MIXER DSP
SAVE DIRECTORY
SHIFT
AUTO REHEARSE
CYCLE PRE-ROLL
EXT. TIME
GRAB TIME
GOTO
EXIT UNDO EXECUTE
COPY CUT ERASE PASTE INSERT TRIM
EDIT CUE IN OUTSYNC SELECT CUE
CURSOR
JOG
SPOOL
NUDGE DATA ENTRY/NUDGE
ENABLE
LEVEL
PAN LINE OUT
HEADPHONE
LEVEL
OUT A
OUT B
SET
SET
SET
SET
SET
SET SET
SHOW
MACRO REC
OFFSET
REVERSE
> CUT DISCARD IN > NOW
REDO
STORE
JOG/SPOOL
ZOOM OUT ZOOM IN
TRACK ZOOM
F1 F2 F3 F4 F5 F6
L R MIN MAX
MI MAX
UTILITIES EDITAUTOLOCATOR NUMERIC ENTRY
PLAYSHEET
+12dB
0dB
PLAY
123
456
789
0
CLR
-/< +/>
00
FRO
LAST TO
OVER
IN
OUT
FROM
REC
LOAD
Once you have a number of projects saved, it follows that you will want to load them into
the DD1500. You may also want to initialise the DD1500 in order to create a project from
scratch.
LOAD
Pressing SHIFT+SAVE (LOAD) will give you this screen:
Here you can see a list of projects on the currently selected disk. As is the convention in
file lists, if there are projects ‘above’ or ‘below’ the screen, an upwards and/or downwards
pointing arrow will be shown ( / ). You may view and load projects on other disks by
moving the cursor to the DISK field and selecting an external drive as appropriate.
To load a project, simply select the one you want and press the flashing EXECUTE key.
The project will be loaded and you will leave the load page. The following prompt will flash
up on the screen to confirm the project is loaded:
To Next Page
Loading...
