Parameter Set-up:
Trigger Delay (Sec): set the relay trigger delay timing (Ranging
from 1-10 Sec.) For example, if you set the delay time as “5” sec.
then the relay will not triggered until 5 seconds after you press
“unlock “ tab.
Hold Delay (Sec): set the relay hold delay timing (Ranging from
1-10 Sec.) For example, if you set the hold delay time as “ 5” Sec.
then the relay will be delayed for 5 after the door is unlocked.
DTMF Mode: select the number of DTMF digit for the door access
control (Ranging from 1-4 digits ) For example, you can select 1