Initializing the System and Downloading Software
Page 62 7210 SAS-D Installation Guide
Enter the location of the configuration file. Or none since you are booting for the first
time.
Boot Interface Management
-------------------------
You specified a network location for either the
software or the configuration file. You need to,
configure either uplinkA or uplinkB ports.
You will be asked to configure the port number, IP address,
static routes, and VLAN Id for uplink ports.
uplinkA Port Setting
--------------------
Existing uplinkA port settings are:
uplinkA-port 1/1/1
uplinkA-address 0
uplinkA-vlan 0
uplinkA port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
Type edit.
Existing uplinkA port for Boot Interface Management is port 1/1/1.
Press ENTER to keep it.
Enter the new uplinkA port number for Boot Interface Management:
Enter the port which it connected to the network (for example, 1/1/10).
You need to assign an IP address for this port.
The IP address should be entered in standard
dotted decimal form with a network length.
example: 192.168.1.169/10
To Next Page
Loading...
