Configuring the 7210 SAS-D
7210 SAS-D Installation Guide Page 63
Or type "0" to obtain IP address and static route
through DHCP. Existing IP address and static routes
will be deleted.
uplinkA port is configured to obtain IP address and static route through
dhcp.
Press ENTER to keep it.
Enter uplinkA port IP Address:
Enter the IP address and the mask that the device should use (for example,
10.135.4.172/10).
Since the FTP server is on a different subnet, you will have to enter IP routing
information:
You specified network locations which might require
static routes to reach. You will be asked to
enter static routes until all the locations become
reachable.
Static routes should be entered in the following format:
prefix/mask next-hop ip-address
example: 192.168.0.0/16 next-hop 192.168.1.254
Would you like to add a static route? (yes/no)
Type yes and press Enter.
Enter route:
Enter a static route to the FTP server’s subnet (for example, 10.10.170.0/10
next-hop 10.135.4.1) at the prompt.
You need to configure the VLAN Id for this port
VLAN Id can be between 0 to 4094. To send out
packets with out any VLAN tags, type "null".
Existing VLAN Id for uplinkA port is VLAN Id 0.
Press ENTER to keep it.
Enter the new VLAN Id for uplinkA port:
To Next Page
Loading...
