Show Commands
Page 142 7210 SAS M, X Basic System Configuration Guide
Sample Output for 7210 SAS-M devices configured in Network mode:
*A:ALA# show bof cf1:
===============================================================================
BOF on cf1:
===============================================================================
primary-image ftp://*:*@10.135.16.90/./images/auto-boot/solution/bothx.tim
secondary-image ftp://*:*@10.135.16.90/./images/auto-boot/solution/bothx.tim
tertiary-image ftp://*:*@10.135.16.90/./images/auto-boot/solution/both.tim
primary-dns 135.254.244.204
dns-domain in.lucent.com
ping 10.135.16.90
#uplinkA Port Settings:
uplinkA-port 1/1/1
uplinkA-address 192.168.1.11/24
uplinkA-vlan 0
uplinkA-route 10.135.0.0/16 next-hop 192.168.1.1
autonegotiate
No autonegotiate — Autonegotiate not enabled.
autonegotiate — Autonegotiate is enabled.
console speed
The console port baud rate.
ping-address
The IPv4 IP address to be used for ping-test after auto-init.
dns domain
The domain name used when performing DNS address resolution.
uplinkA-address
Displays the Uplink-A IP address.
uplinkA-port
Displays the primary port to be used for auto-boot.
uplinkA-route
Displays the static route associated with Uplink-A.
uplinkA-vlan
Displays the VLAN ID to be used on Uplink-A.
uplinkB-address
Displays the Uplink-B IP address.
uplinkB-port
Displays the secondary port to be used for auto-boot.
uplinkB-route
Displays the static route associated with Uplink-B.
uplinkB-vlan
Displays the VLAN ID to be used on Uplink-B.
uplink-mode
This parameter displays the uplink mode of the device. 7210 SAS M
devices can be configured in either Network mode or Access uplink
mode.
no-service-ports
Displays the ports on which service traffic is not processed.
use-expansion-
card-type
Displays the expansion card type.
Table 15: Show BOF Output Fields (Continued)
Label Description
To Next Page
Loading...
Need help?
General
