Alcatel-Lucent 7210 SAS M - Page 144

Show Commands
Page 144 7210 SAS M, X Basic System Configuration Guide
uplinkB-port 1/1/24
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode access-uplink
no-service-ports 1/1/24 1/1/2
use-expansion-card-type m2-xfp
===============================================================================
A:7210-SAS>show#
Sample output for 7210 SAS-M configured in Access uplink mode:
*A:7210-SAS-M>bof# show bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@135.254.170.22//tftpboot/apai/both.tim
primary-config ftp://*:*@10.135.5.171/./images/mtuUplink.cfg
primary-dns 135.254.246.204
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/24
uplinkA-address 10.135.5.179/24
uplinkA-vlan null
uplinkA-route 10.0.0.0/8 next-hop 10.135.5.1
uplinkA-route 10.135.0.0/16 next-hop 10.135.5.1
uplinkA-route 135.254.0.0/16 next-hop 10.135.5.1
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode access-uplink
===============================================================================
*A:7210-SAS-M>bof#