Monitor CLI Commands
Page 68 7210 SAS M, X Basic System Configuration Guide
id
Syntax id service-id
Context monitor>service
Description This command displays statistics for a specific service, specified by the service-id, at the configured
interval until the configured count is reached.
The first screen displays the current statistics related to the service-id. The subsequent statistical
information listed for each interval is displayed as a delta to the previous display. When the keyword
rate is specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters service-id — The unique service identification number which identifies the service in the service
domain.
sap
Syntax sap sap-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id service-id
Description This command monitors statistics for a SAP associated with this service.
This command displays statistics for a specific SAP, identified by the port-id and encapsulation value,
at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the SAP. The subsequent statistical informa-
tion listed for each interval is displayed as a delta to the previous display. When the keyword rate is
specified, the “rate per second” for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition.
Values sap-id: null [port-id | lag-id]
dot1q [port-id | lag-id]:* | qtag
qinq [port-id | lag-id]:qtag1.qtag2
port-id slot/mda/port
lag-id lag-id
lag keyword
id 1 — 200
qtag1 0 — 4094
qtag2 *, 0 — 4094
dlci 16 — 022
port-id — Specifies the physical port ID in the slot/mda/port format.