Monitor CLI Commands
Page 70 7210 SAS M, X Basic System Configuration Guide
absolute — When the absolute keyword is specified, the absolute rate-per-second value for each 
statistic is displayed. 
far-end ip-address — The system address of the far-end 7210 SAS for the SDP in dotted decimal 
notation.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds 
Values 11 — 60
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead 
of the delta. 
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
Sample Output
A:ALA-12# monitor service id 100 sdp 10 repeat 3
===============================================================================
Monitor statistics for Service 100 SDP binding 10
===============================================================================
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
-------------------------------------------------------------------------------
At time t = 11 sec (Mode: Delta)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
-------------------------------------------------------------------------------
At time t = 22 sec (Mode: Delta)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
-------------------------------------------------------------------------------
At time t = 33 sec (Mode: Delta)
-------------------------------------------------------------------------------
I. Fwd. Pkts. : 0 I. Dro. Pkts. : 0
E. Fwd. Pkts. : 0 E. Fwd. Octets : 0
===============================================================================
A:ALA-12#