Alcatel-Lucent 7705 SAR-8 - Page 101

Security
7705 SAR OS System Management Guide Page 101
Global Password Commands
enable-admin
Syntax enable-admin
Context <global>
Description
The enable-admin command is in the default profile. By default, all users are given access to this
command.
Once the enable-admin command is entered, the user is prompted for a password. If the password
matches, the user is given unrestricted access to all the commands.
There are two ways to verify that a user is in the enable-admin mode:
• Enter the show users command — Administrator can know which users are in this mode
• Enter the enable-admin command again at the root prompt and an error message will be
returned
A:ALU-1# show users
===============================================================================
User Type Login time Idle time
From
===============================================================================
admin Console 10AUG2006 13:55:24 0d 19:42:22
--
admin Telnet 09AUG2006 08:35:23 0d 00:00:00 A
10.20.30.93
-------------------------------------------------------------------------------
Number of users : 2
'A' indicates user is in admin mode
===============================================================================
A:ALU-1#
A:ALU-1# enable-admin
MINOR: CLI Already in admin mode.
A:ALU-1#
Note: See the description for the admin-password command. If the admin-
password is configured in the config>system>security>password context, then
any user can enter the special administrative mode by entering the enable-admin
command.