Event and Accounting Logs
7705 SAR OS System Management Guide Page 295
snmp-trap-group
Syntax snmp-trap-group [log-id]
Context show>log
Description This command displays SNMP trap group configuration information.
Parameters log-id — displays only SNMP trap group information for the specified trap group log ID
Values 1 to 99
Output SNMP Trap Group Output — The following table describes SNMP trap group output fields.
Sample Output
*A:ALU-48>config>log# show log snmp-trap-group
===============================================================================
SNMP Trap Groups
===============================================================================
id name
port address
-------------------------------------------------------------------------------
29 name
162 10.20.30.10
===============================================================================
*A:ALU-48>config>log#
Table 39: SNMP Trap Group Output Fields
Label Description
Log-ID The log destination ID for an event stream
Address The IP address of the trap receiver
Port The destination UDP port used for sending traps to the destination,
expressed as a decimal integer
Version Specifies the SNMP version format to use for traps sent to the trap
receiver. Valid values are snmpv1, snmpv2c, snmpv3.
Community The community string required by snmpv1 or snmpv2c trap receivers
Security-Level The required authentication and privacy levels required to access the
views on this node
To Next Page
Loading...
