Alcatel-Lucent 7705 SAR-8 - Modifying an SNMP Trap Group

Log Management Tasks
Page 234 7705 SAR OS System Management Guide
Modifying an SNMP Trap Group
Use the following CLI syntax to modify an SNMP trap group:
CLI Syntax: config>log
snmp-trap-group log-id
trap-target name [address ip-address] [port port]
[snmpv1 | snmpv2c | snmpv3] notify-community
communityName | snmpv3SecurityName [security-level
{no-auth-no-privacy | auth-no-privacy | privacy}]
The following displays the current SNMP trap group configuration:
ALU-12>config>log# info
----------------------------------------------
...
snmp-trap-group 10
trap-target 10.10.10.104:5 "snmpv3" notify-community "communitystring"
exit
...
----------------------------------------------
ALU-12>config>log#
The following displays an example of the command usage to modify an SNMP trap group:
Example: config# log
config>log# snmp-trap-group 10
config>log>snmp-trap-group# no trap-target 10.10.10.104:5
config>log>snmp-trap-group# snmp-trap-group#
trap-target 10.10.0.91:1 snmpv2c notify-community "com1"
The following displays the SNMP trap group configuration:
ALU-12>config>log# info
----------------------------------------------
...
snmp-trap-group 10
trap-target 10.10.0.91:1 "snmpv2c" notify-community "com1”
exit
...
----------------------------------------------
ALU-12>config>log#