Alcatel-Lucent 7705 SAR-8 - SNMP Trap Group

Log Destinations
Page 200 7705 SAR OS System Management Guide
Accounting log files are created in the \act-collect directory on the compact flash
device. The naming convention for accounting logs is:
actaaff-timestamp.xml.gz
where:
aa is the accounting policy ID
ff is the log file destination ID
timestamp is the timestamp when the file is created, in the same form as for event
logs.
Accounting logs are
.xml files created in a compressed format and have a .gz extension.
The
\act-collect directory is where active accounting logs are written. When an
accounting log is rolled over, the active file is closed and archived in the
\act directory
before a new active accounting log file is created in
\act-collect.
SNMP Trap Group
An event log can be configured to send events to SNMP trap receivers by specifying an
SNMP trap group destination.
An SNMP trap group can have multiple trap targets. Each trap target can have different
operational parameters.
A trap destination has the following properties:
• the IP address of the trap receiver
• the UDP port used to send the SNMP trap
• SNMP version (v1, v2c, or v3) used to format the SNMP notification
• SNMP community name for SNMPv1 and SNMPv2c receivers
• security name and level for SNMPv3 trap receivers
For SNMP traps that will be sent out-of-band through the Management Ethernet port on the
CSM, the source IP address of the trap is the IP interface address defined on the
Management Ethernet port. For SNMP traps that will be sent in-band, the source IP address
of the trap is the system IP address of the 7705 SAR.
Each trap target destination of a trap group receives the identical sequence of events as
defined by the log ID and the associated sources and log filter applied.