SNMP
7705 SAR OS System Management Guide Page 175
general-port
Syntax general-port port-number
no general-port
Context config>system>snmp
Description This command configures the port number used by this node to receive SNMP request messages and
to send replies. Note that SNMP notifications generated by the agent are sent from the port specified
in the config>log>snmp-trap-group>trap-target command.
The no form of the command reverts to the default value.
Default 161
Parameters port-number — the port number used to send SNMP traffic other than traps
Values 1 to 65535 (decimal)
packet-size
Syntax packet-size bytes
no packet-size
Context config>system>snmp
Description This command configures the maximum SNMP packet size generated by this node. If the packet size
exceeds the MTU size of the egress interface, the packet will be fragmented.
The no form of the command reverts to the default value.
Default
1500 bytes
Parameters bytes — the SNMP packet size in bytes
Values 484 to 9216
shutdown
Syntax [no] shutdown
Context config>system>snmp
Description This command administratively disables SNMP agent operations. System management can then only
be performed using the CLI. Shutting down SNMP does not remove or change configuration
parameters other than the administrative state. This command does not prevent the agent from
sending SNMP notifications to any configured SNMP trap destinations. SNMP trap destinations are
configured under the config>log>snmp-trap-group context.
To Next Page
Loading...
