Security
7705 SAR OS System Management Guide Page 93
dscp
Syntax dscp dscp-name
no dscp
Context config>system>security>cpm-filter>ip-filter>entry>match
Description This command configures a DiffServ Code Point (DSCP) name to be used as an IP filter match
criterion.
The no form of the command removes the DSCP match criterion.
Default no dscp
Parameters dscp-name — a DSCP name that has been previously mapped to a value using the dscp-name
command. The DiffServ Code Point may only be specified by its name.
Values be|cp1|cp2|cp3|cp4|cp5|cp6|cp7|cs1|cp9|af11|cp11|
af12|cp13|af13|cp15|cs2|cp17|af21|cp19|af22|cp21|
af23|cp23|cs3|cp25|af31|cp27|af32|cp29|af33|cp31|cs4|
cp33|af41|cp35|af42|cp37|af43|cp39|cs5|cp41|cp42|
cp43|cp44|cp45|ef|cp47|nc1|cp49|cp50|cp51|cp52|cp53|
cp54|cp55|nc2|cp57|cp58|cp59|cp60|cp61|cp62|cp63
dst-ip
Syntax dst-ip {ip-address/mask | ip-address netmask}
no dst-ip
Context config>system>security>cpm-filter>ip-filter>entry>match
Description This command configures a destination IP address range to be used as an IP filter match criterion.
To match on the destination IP address, specify the address and its associated mask; for example,
10.1.0.0/16. The conventional notation of 10.1.0.0 255.255.0.0 may also be used.
The no form of the command removes the destination IP address match criterion.
ptp 123 Performance Transparency Protocol
isis 124 ISIS over IPv4
crtp 126 Combat Radio Transport Protocol
crudp 127 Combat Radio User Datagram
Table 6: IP Protocol IDs and Descriptions (Continued)
Protocol Protocol ID Description
To Next Page
Loading...
