Configuration Commands
Page 116 7750 SR OS Router Configuration Guide
Router Advertisement Commands
router-advertisement
Syntax [no] router-advertisement
Context config>router
Description This command configures router advertisement properties. By default, it is disabled for all IPv6
enabled interfaces.
The no form of the command disables all IPv6 interface. However, the no interface interface-name
command disables a specific interface.
Default disabled
interface
Syntax [no] interface ip-int-name
Context config>router>router-advertisement
Description This command configures router advertisement properties on a specific interface. The interface must
already exist in the config>router>interface context.
Default No interfaces are configured by default.
Parameters ip-int-name — Specify the interface name. If the string contains special characters (#, $, spaces, etc.),
the entire string must be enclosed within double quotes.
current-hop-limit
Syntax current-hop-limit number
no current-hop-limit
Context config>router>router-advert>if
Description This command configures the current-hop-limit in the router advertisement messages. It informs the
nodes on the subnet about the hop-limit when originating IPv6 packets.
Default 64
Parameters number — Specifies the hop limit.
Values 0 — 255. A value of zero means there is an unspecified number of hops.
managed-configuration
To Next Page
Loading...
