Alcatel-Lucent 7750 SR OS - Deleting a Filter Policy; From an Egress SAP; From an Ingress SAP

Filter Management Tasks
Page 342 7750 SR OS Router Configuration Guide
Deleting a Filter Policy
Before you can delete a filter, you must remove the filter association from the applied ingress and
egress SAPs and network interfaces.
• From an Ingress SAP on page 342
• From an Egress SAP on page 342
• From a Network Interface on page 343
• From the Filter Configuration on page 346
From an Ingress SAP
To remove a filter from an ingress SAP, enter the following CLI commands:
CLI Syntax: config>service# [epipe|ies|vpls] service-id
sap port-id[:encap-val]
ingress
no filter
Example
: config>service# epipe 5
config>service>epipe# sap 1/1/2:3
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# no filter
From an Egress SAP
To remove a filter from an egress SAP, enter the following CLI commands:
CLI Syntax: config>service# [epipe|ies|vpls] service-id
sap port-id[:encap-val]
egress
no filter
Example
: config>service# epipe 5
config>service>epipe# sap 1/1/2:3
config>service>epipe>sap# egress
config>service>epipe>sap>ingress# no filter