Alcatel-Lucent 7750 SR OS - Configuring VRRP Policy Components

VRRP
7750 SR OS Router Configuration Guide Page 209
Configuring VRRP Policy Components
Use the CLI syntax displayed below to configure a VRRP policy:
CLI Syntax: config>vrrp
policy policy-id [context service-id]
description string
delta-in-use-limit in-use-priority-limit
priority-event
port-down port-id[.channel-id]
hold-set seconds
priority priority-level [{delta|explicit}]
lag-port-down lag-id
hold-set seconds
number-down number-of-lag-ports-down
priority priority-level [{delta|explicit}]
host-unreachable ip-addr
hold-set seconds
interval seconds
timeout seconds
drop-count consecutive-failures
priority priority-level [{delta|explicit}]
route-unknown prefix/mask-length
hold-set seconds
less-specific [allow-default]
next-hop ip-address
protocol bgp
protocol ospf
protocol isis
protocol rip
protocol static
priority priority-level [{delta|explicit}]
The following output displays an example of a VRRP policy specifying parameter values that
are assumed in the event that a specific port is down:
Example: SR1>config>vrrp#
config>vrrp# policy 1
config>vrrp>policy$ delta-in-use-limit 50
config>vrrp>policy# priority-event
config>vrrp>policy>priority-event# port-down 1/1/2
config>vrrp>policy>priority-event>port-down$ hold-set 43200
config>vrrp>policy>priority-event>port-down# priority 100 delta