Alcatel-Lucent 7750 SR OS - Configuring Router Interface VRRP Parameters

VRRP
7750 SR OS Router Configuration Guide Page 215
Configuring Router Interface VRRP Parameters
VRRP parameters can be configured on an interface in an interface to provide virtual default
router support which allows traffic to be routed without relying on a single router in case of
failure.
VRRP can be configured the following ways:
• Router Interface VRRP Non-Owner on page 216
Use the CLI syntax displayed below to configure owner and non-owner router interface VRRP
parameters:
CLI Syntax: config>router
interface ip-int-name
address ip-addr/mask-length
no shutdown
vrrp vrid
authentication-type {password}
authentication-key [authentication-key | hash-key]
[hash|hash2]
backup ip-addr
init-delay seconds
mac ieee-mac-address
priority base-priority
policy vrrp-policy-id
message-interval seconds
ping-reply
telnet-reply
ssh-reply
no shutdown
vrrp vrid owner
authentication-type {password}
authentication-key [authentication-key | hash-key]
[hash|hash2]
backup ip-addr
init-delay seconds
mac ieee-mac-address
message-interval seconds