IP Router Configuration
7750 SR OS Router Configuration Guide Page 53
Configuring IPv6 Parameters
To configure IPv6 parameters, you must first:
• The chassis mode must be set to c in the config>system>chassis-mode context. Use the
force keyword to upgrade to c mode with cards provisioned as iom-20g or iom-20g-b.
The following displays the interface configuration showing the IPv6 default configuration when
IPv6 is enabled on the interface.
A:ALA-49>config>router>if>ipv6# info detail
----------------------------------------------
port 1/2/37
ipv6
packet-too-big 100 10
param-problem 100 10
redirects 100 10
time-exceeded 100 10
unreachables 100 10
exit
----------------------------------------------
A:ALA-49>config>router>if>ipv6# exit all
Use the following CLI syntax to configure IPv6 parameters on a router interface.
CLI Syntax: config>router# interface interface-name
port port-name
ipv6
address {ipv6-address/prefix-length} [eui-64]
icmp6
packet-too-big [number seconds]
param-problem [number seconds]
redirects [number seconds]
time-exceeded [number seconds]
unreachables [number seconds]
neighbor ipv6-address mac-address?
To Next Page
Loading...
