Alcatel-Lucent 7750 SR OS - Configuring Proxy ARP

Common Configuration Tasks
Page 68 7750 SR OS Router Configuration Guide
Configuring Proxy ARP
To configure proxy ARP, you can configure:
• A prefix list in the
config>router>policy-options>prefix-list context.
• A route policy statement in the
config>router>policy-options>policy-
statement
context and apply the specified prefix list.
→ In the policy statement
entry>to context, specify the host source address(es) for
which ARP requests can or cannot be forwarded to non-local networks, depending on
the specified action.
→ In the policy statement
entry>from context, specify network prefixes that ARP
requests will or will not be forwarded to depending on the action if a match is found.
For more information about route policies, refer to Route Policies on page 597.
• Apply the policy statement to the proxy-arp configuration in the
config>router>interface context.
CLI Syntax: config>router# policy-options
begin
commit
prefix-list name
prefix ip-prefix/mask [exact|longer|through
length|prefix-length-range length1-length2]
The following example displays prefix list configuration command usage. These commands are
configured in the
config>router context.
Example:config>router>policy-options# begin
config>router>policy-options# prefix-list prefixlist1
config>router>policy-options>prefix-list# prefix 10.20.30.0/24
through 32
config>router>policy-options>prefix-list# exit
config>router>policy-options# prefix-list prefixlist2
config>router>policy-options>prefix-list# prefix 10.10.10.0/24
through 32
config>router>policy-options>prefix-list# exit
config>router>policy-options# commit