Configuration Commands
Page 244 7750 SR OS Router Configuration Guide
Parameters vrrp-policy-id — The VRRP priority control ID expressed as a decimal integer that uniquely
identifies this policy from any other VRRP priority control policy defined on the system. Up to
1000 policies can be defined.
Values 1 — 9999
context service-id — Specifies the service ID to which this policy applies. A value of zero (0) means
that this policy does not apply to a service but applies to the base router instance.
Values 1 — 2147483647
priority-event
Syntax [no] priority-event
Context config>vrrp>policy vrrp-priority-id
Description This command creates the context to configure VRRP priority control events used to define criteria to
modify the VRRP in-use priority.
A priority control event specifies an object to monitor and the effect on the in-use priority level for an
associated virtual router instance.
Up to 32 priority control events can be configured within the priority-event node.
The no form of the command clears any configured priority events.
To Next Page
Loading...
