Alienware Aurora R13 - Front Alienfx LED Boards; Removing the Front Alienfx LED Board

Steps
1. Lay the computer on its right side.
2. Align the top-chassis fan with the slot on the chassis.
3. Push the top-chassis fan into the slot on the chassis until its releasing clip is locked into place.
4. Connect the top-chassis fan cable to the system board.
Next steps
1. Install the
left-side cover.
2. Follow the procedure in After working inside your computer.
Front AlienFX LED boards
Removing the Front AlienFX LED board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the top cover.
4. Remove the right-side cover.
5. Remove the front bezel.
71